Stiga 9L3BL Bedienungsanleitung Seite 85

8. Replace the protection (L).
9. Connect the power cord (E) of
the charging station (F) to the
transmitter (B).
10. Connect the plug of the power
supply unit (A) to the electrical
outlet.
11. If the LED (H) fl ashes,the connection
is correct. If not, search for the fault
(see "Troubleshooting Guide")
1. Place the robot inside the charging
station.
2. Press the ON key.
3. After a few seconds, the message
"CHARGING" will appear on the
display.
4. Press the "Start/Pause" key. The
"PAUSE" function appears on the
display. The batteries start the
charging cycle.
5. At the end of the charging, the
robot can be programmed for the
initial start-up (see "Programming
Mode").
On fi rst recharge, the batteries must remain connected for at least 24 hours
power cord (E)
charging station
BATTERY CHARGE ON FIRST USE
27
protection (L)
transmitter (B)
led (H)
H. min. 160 cm
(63.00 inc.)
"ON" "START/PAUSE" KEY
current power
supply unit (A)
Perimeter
wire
User's manual
EN