Stiga 9L3BL Bedienungsanleitung Seite 98

The start-up of the automatic cycle is
executed on the initial start-up or after a
period of inactivity.
1. Check that the height of the lawn surface
to mow is compatible with the correct
functioning of the robot (see "Technical
Specifi cations").
EN
2. Adjust the cutting height as desired (see
"Adjustment of Cutting Height).
3. Check that the work area has been
correctly marked and that there are no
impediments to the regular functioning
of the robot as indicated in the section
"Preparation and Marking the Boundaries
of the Work Areas" and following sections.
4. Position the robot inside the charging station.
5. Press the ON key and wait a few seconds for the robot to turn on completely.
6. If starting the robot for the fi rst time, it is necessary to program the settings. However, if
starting the robot after a long period of inactivity, check that the programmed functions
correspond to the actual state of the lawn to mow (e.g. addition of a pool, plants, etc.) (see
"Programming Mode").
7. After a few seconds, the message "CHARGING" will appear on the display.
8. The robot starts to mow the lawn according to the methods programmed.
During use, it may be necessary to stop the robot. In normal conditions, the robot can be
stopped with the "OFF/STOP" key. In case of danger or when performing any maintenance,
it is necessary to safely stop the robot in order to prevent the blade from accidently starting.
Press the "STOP/Emergency" key (A) to stop the robot. Press the "STOP/Emergency" key (A)
again to restart the robot.
The robot
when carrying out any maintenance and
repairs (for example, replacement and/or
recharging of the battery, replacement of
the blade, cleaning operations, etc.).
User's manual
INITIAL STARTUP – AUTOMATIC MODE
ROBOT SAFETY STOP
safety stop is necessary
"START/PAUSE" KEY (B)
"ON" KEY (A)
"OFF/STOP" KEY (C)
"OFF/STOP" KEY (A)
40