Stiga 9L3BL Bedienungsanleitung Seite 103

PROLONGED INACTIVITY AND RESTARTING
If the robot has not been used for a long
period of time, it is necessary to perform a
series of operations to guarantee the correct
functioning at the time of reuse.
1. Accurately clean the robot and charging
station (see "Robot Cleaning").
2. Recharge the battery at least every fi ve
months if using lithium batteries (see
"Recharging batteries after prolonged
inactivity").
3. Store the robot in a protected and dry
location with an ambient temperature
between 10° and 25° C (50°F - 77°F), out
of reach of children, domestic animals, etc.
4. Disconnect the power plug from the power
supply unit (A).
5. Cover the charging station (C) to prevent
any foreign materials from getting inside
(leaves, paper, etc.) and for preserving the
contact plates.
Restarting
Before restarting the robot after a long period
of inactivity, proceed as follows.
1. Connect the plug of the power supply unit
(A) to the electrical outlet.
2. Reconnect the main electrical power
supply.
3. Place the robot inside the charging station.
4. Press the ON key (A).
5. Enter the password (if prompted) (See
"Password Entry").
6. After a few seconds,
"CHARGING" will appear on the display.
7. At this point, the robot is ready to use (see
"Programming Mode").
charging
Station (C)
the message
45
Current power
supplyunit (A)
"ON" KEY (A)
EN
User's manual