Stiga 9L3BL Bedienungsanleitung Seite 81

Wire laid on the ground
1. Position the wire in a clockwise direction
along the entire track and secure it with the
pegs supplied (distance of 100÷200 cm
(39.37÷78.74 in.) between each peg).
– When laying the perimeter wire make
sure to respect the rotation direction
around the fl owerbeds (anti-clockwise).
– In straight stretches, fasten the wire so
that it is not too tight, curved and/or
twisted.
– In stretches that are not straight, fasten
the wire so that it is not twisted but
curves in a regular manner.
Buried wire
1. Dig up the ground in a regular and symmetrical manner with respect to the line traced on
the ground.
2. Position the wire in a clockwise direction along the entire length of the track at a depth of a
few centimetres (around 2÷3 cm (0.7874÷ 1.1811 in.)) so as not to reduce the quality and
intensity of the signal picked up by the robot.
3. During the laying of the wire, if necessary, secure it in some points with the pegs provided
in order to hold it in place when covering with the dirt.
4. Cover the wire with the dirt and make sure it does not twist, but remains straight, and make
sure the curved sections are regular.
OK
wire fastening pegs
23
wire fastening pegs
perimeter wire
NO
perimeter wire
User's manual
EN