Troubleshooting Guide - Stiga 9L3BL Bedienungsanleitung

The information below is designed to help identify and correct any faults and/or malfunctions
which may occur during operation. Some failures can be fi xed by the user, while others require
specifi c technical skills or special abilities and therefore must only be fi xed by qualifi ed per-
sonnel with certifi ed experience gained in the specifi c fi eld of intervention.
Problem
The antitheft alarm
continues to operate
The antitheft alarm
does not work
The robot is very noisy
The robot does
not position itself
correctly inside the
charging station
TROUBLESHOOTING

TROUBLESHOOTING GUIDE

Cause
Alarm enabled
Alarm disabled
Cutting blade
damaged
Cutting blade fouled
(tape, cords, plastic
fragments, etc.)
The robot was star-
ted in the presence
of obstacles (fallen
branches, forgotten
objects, etc.)
Electric motor failure
Grass too high
Incorrect positioning
of the perimeter wire
or power cord of the
charging station
Collapsing of ground
next to the charging
station
49
Remedies
Disable the alarm
(see "Programming Mode")
Enable the alarm (see "Programming Mode")
Replace the blade with a new one
(see "Blade Replacement")
Stop the robot safely (see "Robot Safety
Stop"). Unclog the blade
Warning - Caution
Use protective gloves to prevent injury.
Stop the robot safely
(see "Robot Safety Stop")
Remove the obstacle and restart the robot
(see "Start-up and manual stopping of the
robot (in closed areas)")
Have the motor replaced or repaired by your
nearest authorised service centre
Increase the cutting height
(see "Adjustment of cutting height")
Carry out a preliminary cutting of the area
with a normal lawnmower
Check the connection of the charging station
(see "Installation of the charging station and
power supply-transmitter unit")
Position the charging station on a fl at
and stable surface
(see "Planning of plant installation")
EN
User's manual