Stiga 9L3BL Bedienungsanleitung Seite 112

"Watchdog error"
appears on the display
EN
"Tilt" appears on the display
(C)
User's manual
Problem
The led
( c ) does
not turn
on
LED (C)
of the
transmit-
ter is on
Cause
The internal "softwa-
re safety" system is
enabled
The robot is located
on a level that is hi-
gher than the allowed
limits
The robot is located
on a level that is lo-
wer than the allowed
limits
No power supply
Interrupted fuse
Interrupted perimeter
wire
54
Remedies
Turn the robot off and on. If the
problem persists, contact your
nearest authorised service centre
Mark off the area that is too steep
Check that the charging station
is positioned on a fl at surface.
Turn the robot off and on while
in the charging station and try
again. If the problem persists,
contact your nearest authorised
service centre
Make sure the power supply unit
is correctly connected to the po-
wer outlet
Have the fuse replaced by your
nearest authorised service centre
Stop the robot safely (see "Robot
Safety Stop").
Disconnect the power plug from
the power supply unit.
Join the perimeter wire.