Stiga 9L3BL Bedienungsanleitung Seite 108

Problem
The robot does not
behave
around the fl owerbeds
EN
The robot works at
the wrong time
The robot does not
execute the
quick re-entry
The work area is not
completely mowed
User's manual
Cause
Perimeter wire laid
correctly
incorrectly
Clock was set
incorrectly
Working time was set
incorrectly
Quick re-entry not
setup correctly
Not enough work
hours
Cutting blade fouled
Cutting blade worn
out
Work area too big
compared to the
actual capacity of the
robot
The batteries are
about to run out
The batteries do not
charge completely
Remedies
Reposition the perimeter wire correctly
(anti-clockwise direction
(see "Installation of perimeter wire")
Reset the clock of the robot
(see "Programming Mode")
Reset the working time
(see "Programming Mode")
Check the exact layout of the quick re-entry
(see "Layout of the robot's quick re-entry to
the charging station")
Reset the working time
(see "Programming Mode")
Stop the robot safely
(see "Robot Safety Stop").
Warning - Caution
Use protective gloves to prevent injury.
Clean the cutting blade
Replace the blade with an original spare part
(see "Blade replacement")
Adjust the work area
(see "Technical specifi cations")
Replace the batteries with original spare
parts (see "Battery replacement")
Clean and remove any oxidisations from the
contact points of the batteries (see "Robot
Cleaning"). Recharge the batteries for at
least 12 hours
50