Stiga 9L3BL Bedienungsanleitung Seite 111

Problem
"Sync error" appears
on the display
"Too high grass" or
"Blade Error" appe-
ars on the display
The remote control
does not work
Cause
The robot's receiver
does not recognise
the signal
Cutting blade da-
maged
Cutting blade fouled
(tape, cords, plastic
fragments, etc.)
The robot was
started too close to
obstacles (less than
a distance of m) or
in the presence of
obstacles (fallen
branches, forgotten
objects, etc.)
Electric motor failure
Too high grass
Programming error
The LED of the remo-
te control does not
light up
53
Remedies
Turn the robot off and then turn it back on
again. If the problem persists, contact your
nearest authorised service centre
Replace the blade with a new one
(see "Blade Replacement")
Stop the robot safely
(see "Robot Safety Stop")
Warning - Caution
Use protective gloves to prevent injury.
Unclog the blade
Stop the robot safely
(see "Robot Safety Stop")
Remove the obstacles and restart the robot
(see "Start-up and manual stopping of the
robot (in closed areas)")
Have the motor replaced or repaired by your
nearest authorised service centre
Increase the cutting height (see "Adjustment
of cutting height")
Carry out a preliminary cutting of the area
with a normal lawnmower
Correctly program the remote control
(see "Programming Mode")
Remove the batteries and replace them
(see "Replacement of remote control batteries")
EN
User's manual