Stiga 9L3BL Bedienungsanleitung Seite 70

operations provided for by the Manufacturer. Proper maintenance will allow obtaining the best
performances and longer operating times.
• Before carrying out any maintenance and adjustments disconnect the electric power supply.
The user must ensure that all the necessary safety conditions are in place, especially when
working on the lower part of the lawn mower, and must follow the Manufacturer's procedures
and instructions.
• Use the personal protection devices prescribed for by the Manufacturer, in particular, always
wear protective gloves when working on the cutting blade.
EN
• Before replacing the batteries, always remove the blade.
• Make sure the air openings of the power supply unit are free and clear of residuals.
• In order to not irreversibly damage the electric and electronic parts, do not wash the robot with
high-pressurised water and do not immerse it in water, partially or completely, since it is not
watertight.
• Only qualifi ed persons, having the necessary technical expertise and skill, should attempt to work
on or repair this robot. Failure to observe these requirements could result in serious injury.
• Any work to be performed on the charging station must be carried out with the plug of the
power cord disconnected.
• Replace any worn or deteriorated parts with original spare parts to ensure proper functionality
and safety.
• The robot cannot be used without the upper cover; if the mechanical parts of the robot are
damaged, they must be replaced.
• Any routine or extraordinary maintenance (e.g. battery replacement) must be performed by an
authorised service centre.
• The Manufacturer shall not be held liable if non-original spare parts are used.
• Never use and recharge the robot in explosive and/or fl ammable environments.
User's manual 12