Stiga 9L3BL Bedienungsanleitung Seite 76

If the robot is installed next to an area
which has another robot (by the same or by
a different manufacturer), then the power
supply-transmitter unit must be modifi ed
during installation so that the frequencies
of the two robots do not interfere with each
other.
EN
Before installing the perimeter wire, it is
necessary to check the entire surface of the
lawn. Make any necessary adjustments to
the grassy surface during the laying of the
perimeter wire in order to allow the robot to
operate properly.
1. Proceed with "Preparation and marking the
boundaries of the work areas (see page 19).
2. Installation of the perimeter wire (see page
22).
3. Installation of the charging station and power
supply-transmitter unit (see page 25).
4. When laying the perimeter wire, respect the
installation direction (clockwise) and the ro-
tation direction around the fl owerbeds (anti-
clockwise), as shown in the fi gure.
User's manual
SETTING UP THE PERIMETER WIRE
18
track for laying the perimeter wire
24 v