Edit Profiles - Heidolph Hei-TORQUE Expert Betriebsanleitung

Operation

Edit profiles

You can edit up to seven profiles and save them as favorites.
The timer of each profile step always counts down to zero. This
means that each subsequent profile step must always be at least
1 minute higher than the previous step. – Exception: Ending the
profile cycle.
Example:
Time = 00:02
Rotation = 200
1 step:
st
Ramp =
Time = 00:03
Rotation = 400
2 step:
nd
Ramp =
Time = 01:00
Rotation = 400
3 step:
rd
Ramp = l
➜ Open the submenu.
➜ Select the "Edit profile" menu
item.
➜ Push the control knob and select
the rotation time by turning the
control knob.
➜ Push the control knob to confirm
and select the speed by turning
the control knob.
➜
Push the control knob to confirm
selection.
– The profile symbol is now
displayed in orange.
Ramp icon
l
: The speed immediately ramps up to the pre-programmed rpm settings for the
pre-programmed time.
/
: The speed increases (or decreases) gradually within the pre-programmed time
until it reaches the pre-programmed rpm setting.
➜ Choose your desired ramp by
turning the control knob clockwise
or counterclockwise.
➜ Push the control knob to confirm
selection.
➜
The positioning indicator jumps to
the next row.
➜ Enter the next ramp.
Speed increases to 200 rpm within 2 minutes.
l
Speed increases to 400 rpm between the 2
and the 3
l
Speed remains at 400 rpm between the 3
the 60 minute.
th
79
minute.
rd
hh : mm rpm l
00 : 00
rpm l
0
00. 02 l
l
00 : 02 200
l
00 : 02 200
/
00 : 02 200
00 : 02 200 /
hh : mm rpm l
nd
and
rd