Interfaces; Connect And Link Interfaces - Heidolph Hei-TORQUE Expert Betriebsanleitung

Operation

Interfaces

Hei-TORQUE Ultimate only
You can connect the stirrer to a PC via the interface. Two serial interfaces are located on
the back of the device. (Operation: see separate manual).
The following interfaces are available:
USB interface: Micro USB type AB
RS232 interface, SUB D9
You can connect the device either via
USB or via the RS232 interface.
Up to 4 overhead stirrers can be
driven via numerous PC interfaces.
➜
Close the dust protection cap on
the interface if not in use.
Software
Installation and operation of the software program is described in a separate manual.
Utilize USB port according to USB 2.0 Spec. up to 500 mA
maximum.

Connect and link interfaces

Warning: Danger of electric shock!
If the interface inputs and outputs are supplied with excessively high
voltage and are not sufficiently insulated, in the event of a fault,
metallic parts (e.g. the housing), will be electrified.
Voltage inputs and outputs above 25 V AC or 60 V DC are deemed
safe if separated according to DIN EN 61140, or by double or
reinforced insulation in accordance with DIN EN 60730-1 or DIN
60950-1.
Only use shielded connection cables. Connect shield to connector
case.
Caution: Possible damage of device
If device sockets are not covered, fluids can get in contact with
Interface connectors. Penetrating fluids can lead to malfunctions of
interface connection and could initiate a short circuit.
Sockets at the backside of device must be covered at all times.
USB interface dust
protection cap
RS 232 interface
USB port
93