Table Cutting Speed; Important Notes On Ip44 Version; Maintenance And Safety Check - Jackle Plasma 40i IP44 Betriebsanleitung

22. Table cutting speed

The following table is a reference point for the cutting speed:
Material Nozzle
thickness Diameter
0,5 – 1,0mm 0,65mm
2,0mm 0,65mm
3,0mm 0,65mm
4,0mm 0,8 / 0,9mm
6,0mm 0,8 / 0,9mm
8,0mm 0,8 / 0,9mm
10,0mm 0,8 / 0,9mm
15,0mm * 0,8 / 0,9mm
20,0mm * 0,8 / 0,9mm
* only severance cut

23. Important notes on IP44 version

Attention:
IP44 means that the cutting device is protected against water (rainfall) from all directions.
It must never be placed in standing water or similar.
Further, the torch is not designed to work waterproof, so he also should not be touched with standing water.
Plasma cutting is performed by means of high voltage and current. Because water conducts electricity, the
cutting surface and its environment must be free of water, and the cutting area to be protected from rain water to
avoid electrocution. It must never be cut in the water.
When working with plasma cutters outdoors or in moist environments, greater attention is needed!

24. Maintenance and safety check

The cutting unit is, on principle, maintenance-free. However, make it a rule to carry out the following work:
Clean the welding unit by air-blasting from inside according to pollution level.
Attention:
This Welding unit has to be safety checked every year by JÄCKLE Company or another special qualified
electrician according to the harmonized standard
IEC 60974 – 4
Safety, maintenance and inspection of arc welding equipment in use
Operating manual
Cutting
current
20A
20A
25A
30A
35A
40A
40A
40A
40A
Disconnect mains prior to any service and maintenance work!
Steel Aluminium
2500 mm/min 2750 mm/min
1400 mm/min 1650 mm/min
1200 mm/min 1500 mm/min
1000 mm/min 1400 mm/min
750 mm/min 750 mm/min
700 mm/min 750 mm/min
480 mm/min 450 mm/min
250 mm/min 300 mm/min
150 mm/min
Plasma 40i
Stainless
steel
2200 mm/min
1200 mm/min
1050 mm/min
900 mm/min
600 mm/min
550 mm/min
460 mm/min
200 mm/min
- 90 mm/min
Page 20