Important
Before carrying out any replacement proce-
dure, activate all the safety devices provided
and decide whether staff at work and those
in the vicinity should be informed. In particu-
lar, turn off the gas supply tap and prevent
access to all devices which might cause un-
expected health and safety hazards if turned
on. If work parts have to be replaced, use
original spare parts only.
To carry out this operation, proceed as follows.
Turn off the gas supply
1)
tap.
Remove the grid (A).
2)
Extract the burner (B).
3)
Unscrew the nozzle (C)
4)
and replace it with the
one suitable for the type
of gas in use (see table at
back of manual).
Replace the burner and
5)
the grid.
GB
To carry out this operation, proceed as follows.
Turn off the gas supply
1)
tap.
Remove the grid (A).
2)
Extract the burner (B).
3)
Unscrew the nozzle (C)
4)
and replace it with the
one suitable for the type
of gas in use (see table at
back of manual).
Replace the burner and
5)
the grid.
3320050_inst_GB_rev.1
REPLACING PARTS
INSTRUCTIONS AND WARNING FOR REPLACING PARTS
REPLACING THE TOP BURNER NOZZLE (Ø 80 - 4 KW)
A
REPLACING THE TOP BURNER NOZZLE (Ø 110 - 7 KW)
A
The manufacturer declines all responsibly for
injury or damage to components due to the
use of non original parts, or extraordinary
work on the appliance which may modify the
safety requirements without the manufac-
turer's authorisation. When ordering compo-
nents, follow the instructions provided in the
parts catalogue.
B
B
- 16 -
8
C
8
C
ENGLISH