Testing Of The Appliance; Adjustments; Instructions And Warnings For Adjustments; Replacing Parts - Angelo Po 1N1TPEE Bedienhandbuch

Important
Before it is put into service, the system must
be tested to check the operating conditions
of every single component and identify any
malfunctions. In this stage, it is important to
check that all health and safety requirements
have been complied with in full.
To test the system, make the following checks:
Check that the mains voltage is the same as
1)
that of the appliance.

INSTRUCTIONS AND WARNINGS FOR ADJUSTMENTS

The appliance's main functions do not require
any special adjustments by specialist staff except
the settings made during use by the user.

INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS

The appliance does not require the replacement
of operating components by specialist staff
except the replacement of standard parts which
can be carried out by the user.

DECOMMISSIONING AND SCRAPPING THE APPLIANCE

When decommissioning the appliance, a series
of procedures must be carried out to ensure that
the appliance and its components are not a hin-
drance and are not easily accessible.
To ensure that the appliance cannot constitute
hazards for people or the environment, all energy
sources (electricity, etc.) must be disconnected
and rendered unusable, and any liquids present
must be drained (lubricants, fl uids, etc.).
Place the appliance in a suitable area which is not
easily accessible, with barriers to prevent anyone
from accessing it.
3326541_inst_GB

TESTING OF THE APPLIANCE

ADJUSTMENTS

REPLACING PARTS

- 11 -
Operate the appliance's circuit-breaker to
2)
check the electrical connection.
Check that the safety device is operating
3)
correctly.
After testing, if necessary instruct the user in all
the skills necessary for putting the appliance
into operation in conditions of safety, in accor-
dance with legal requirements.
When scrapping, sort all components by chemi-
cal characteristics and dispose of them separate-
ly in accordance with the relevant legal require-
ments.
Important
Do not dump non-biodegradable products,
lubricating oils, and non-metallic compo-
nents (rubber, PVC, resins, etc.) in the envi-
ronment. Dispose of them in compliance with
the relevant laws.
GB
ENGLISH