Adjusting Top Burner Primary Air (7 Kw); Adjusting Top Burner Primary Air (10 Kw); Greasing The Gas Tap - Angelo Po 1N1FAE Bedienshandbuch

To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screw (D).
4)
Set the burner mount (E) at a distance of 20
5)
mm, and tighten the screw (D).
Replace the control panel (B) and the knob
6)
(A) on completion of the operation.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screw (D).
4)
Set the burner mount (E) at a distance of 20
5)
mm, and tighten the screw (D).
Replace the control panel (B) and the knob (A)
6)
on completion of the operation.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Undo the screws (D) and extract the cap (E).
4)
Pull off the cone (F).
5)
Clean the cone (F) and its seat.
6)
Coat the cone with grease (F), fi t it in its seat
7)
and turn it a few times.
Pull off the cone (F) to remove the excess
8)
grease.
Replace the cone (F) and the cap (E).
9)
Replace the control panel (B) and the knob
10)
(A) on completion of the operation.
3320050_inst_GB_rev.1

ADJUSTING TOP BURNER PRIMARY AIR (7 KW)

ADJUSTING TOP BURNER PRIMARY AIR (10 KW)

GREASING THE GAS TAP

A
B
A
B
A
B
- 15 -
C
C
C
C
E
C
C
D
D
D
GB
F
ENGLISH