Even if the equipment has all its safety devices,
if necessary, during the installation and con-
nection other safety devices may be supple-
mented in accordance with applicable laws.
The illustration shows the position of the
devices.
Gas supply tap: for turning the connection to
A)
the gas supply line on and off .
Safety thermocouple: cuts out the gas sup-
B)
ply if the fl ame goes out.
Safety thermostat: cuts off the electricity
C)
supply in case of overheating.
Important
Make a daily check that the safety devices are
properly installed and in good working order.
The illustration shows the position of the signs
provided.
Nameplate with manufacturer and
A)
appliance data.
General hazard: read the manual carefully
B)
before carrying out any procedure.
General hazard: when washing the applian-
C)
ce do not point pressurised water jets at
internal parts.
General hazard: all relevant regulations
D)
must be complied with. "Install in complian-
ce with the relevant regulations and use in
well ventilated premises only".
General hazard: all relevant regulations
E)
must be complied with. "No liability is ac-
cepted in case of failure to comply with the
installation and commissioning instructions".
Burn hazard: watch out for hot surfaces.
F)
CE marking: this indicates that the
G)
equipment is compliant with all relevant laws
applicable to the product.
3320050_ut_GB_rev.1
SAFETY DEVICES
SAFETY AND INFORMATION SIGNS
- 5 -
B
C
E
D
F
37M3202
C
B
A
GB
GB
G
A
ENGLISH