Startup And Operation; Startup; Operation; Operating Notes - Balluff BOS R254K-UUI-LH10-S4 Betriebsanleitung

BOS R254K-UUI-LH10-S4
Photoelectric Sensors
6

Startup and operation

6.1

Startup

DANGER
Uncontrolled system movement
When starting up, if the sensor is part of a closed loop
system whose parameters have not yet been set, the
system may perform uncontrolled movements. This
could result in personal injury and equipment damage.
► Persons must keep away from the system's
hazardous zones.
► Startup must be performed only by trained technical
personnel.
► Observe the safety instructions of the equipment or
system manufacturer.
CAUTION
Visible laser radiation
If you look into the laser beam, temporary blinding and
irritation of the eyes is possible.
► Do not look into the laser beam!
1. Check connections for tightness and correct polarity.
Replace damaged connections.
2. Turn on the system.
3. Check measured values and adjustable parameters
and realign and adjust the sensor, if necessary.
Check for the correct values, especially after
replacing the sensor or after repair by the
manufacturer.
6.2

Operation

CAUTION
Visible laser radiation
If you look into the laser beam, temporary blinding and
irritation of the eyes is possible.
► Do not look into the laser beam!
No additional protection measures are required (Laser
Class 1 per IEC 60825-1:2014).
6.3

Operating notes

– Regularly check function of the sensor and all
associated components.
– Take the sensor out of service whenever there is a
malfunction.
– Secure the system against unauthorized use.
– Check fasteners and retighten if needed.
www.balluff.com
6.4

Cleaning

Keep the lens as free from soiling as possible (dust etc.)
and do not touch it (fingerprints).
Remove soiling
► Wipe off the lens with a lint-free cloth and alcohol
(ethanol, isopropanol).
6.5

Maintenance

The product is maintenance-free.
english 9