Startup And Operation; Startup; Operating Notes; Cleaning - Balluff BES M08EH1-L01C20B-S04G-L04 Betriebsanleitung

BES M08EH1-L01C20B-S04G-L04 /BES M12E_1-L01C_0_-S04G-L04 /
BES M18EH1-L01C_ _ _-S04G-L04
Inductive sensors
6

Startup and operation

6.1

Startup

DANGER
Uncontrolled system movement
When starting up, if the sensor is part of a closed loop
system whose parameters have not yet been set, the
system may perform uncontrolled movements. This
could result in personal injury and equipment damage.
► Persons must keep away from the system's
hazardous zones.
► Startup must be performed only by trained technical
personnel.
► Observe the safety instructions of the equipment or
system manufacturer.
1. Check connections for tightness and correct polarity.
Replace damaged connections.
2. Turn on the system.
3. Check measured values and adjustable parameters
and readjust the sensor if necessary. Check spacing
over the entire measuring range.
Check for the correct values, especially after
replacing the sensor or after repair by the
manufacturer.
6.2

Operating notes

– Regularly check function of the sensor and all
associated components.
– Take the sensor out of service whenever there is a
malfunction.
– Secure the system against unauthorized use.
– Check fasteners and retighten if needed.
www.balluff.com
6.3

Cleaning

The product is resistant to numerous alkaline, neutral and
acidic cleaning media based on peroxyacids and amines
with and without chlorine for the food and beverage
industry. For further information, see ECOLAB certificate at
www.balluff.com on the product page.
In case of surface damage or malfunctions, the product
must be taken out of operation immediately.
► Clean product regularly.
The cleaning intervals depend on the ambient conditions
and the frequency of use.
6.4

Maintenance

The product is maintenance-free.
english 11