Cleaning And Servicing; Troubleshooting - Bosch MUM 81 Serie Gebrauchsanleitung

en
Important information
!
The appliance will not switch on unless
the tool drive cover (11) is attached and the
blender cover is attached and locked.
When working, hold the blender cover by
the edge.
Adding more ingredients
S Switch off the appliance with the rotary
switch.
S Remove the cover and add ingredients
or
S take out the funnel on the blender cover and
gradually add solid ingredients via the feed
tube
or
S pour in liquid ingredients through the funnel.
After work
S Switch off the appliance with the rotary
switch.
S Pull out the mains plug.
S Rotate the blender in a clockwise direction
and remove.
Tip: It is recommended to clean the blender
immediately after use.

Cleaning and servicing

Cleaning the base unit
d
Risk of electric shock
Never immerse the base unit in water
and never clean under running water.
Do not use a steam cleaner.
d Attention!
Do not use abrasive cleaning agents.
S Pull out the mains plug.
S Wipe the base unit and drive cover with
a damp cloth. If required, use a little
washing up liquid.
S Then wipe the appliance dry.
Cleaning the bowl and tools
The bowl and tools are dishwasher safe.
Do not wedge plastic parts in the dishwasher,
as they could be permanently deformed during
the washing process!
12
Cleaning the blender
!
d
Risk of injury from sharp blades
Do not touch blender blades with bare
hands. Use a brush for cleaning.
d Attention!
Do not use abrasive cleaning agents.
Fig. 8
Do not clean the blender in the dishwasher.
Do not leave the blender in water.
It is recommended to clean the blender
immediately after use. This will prevent residue
from drying on and attacking the plastic
(e. g. by essential oils in herbs).
S Clean the blender cover in the dishwasher.
S Clean the blender under running water.
Tip: Pour water with a little washing up liquid
into the attached blender (approx. half full).
Switch on the blender for several seconds
(setting M). Pour out the water and rinse out
the blender with clear water.

Troubleshooting

d
Before eliminating a fault, pull out the mains
plug.
The swivel arm must be engaged in every
operating position.
First try to eliminate the problem with the aid of
d
the information in the following table.
Fault
Tool does not
stop in the tool
change
position.
Appliance does pp
not start/restart t t t/
lock out is lock out is
active
Risk of injury
Remedial action
S Switch appliance to 0/off
and switch on again.
Switch off after several
seconds.
S Check the power supply.
t t
S Check the mains plug.
S Switch appliance to 0/off
and then back to the
required setting.
S Check swivel arm.
Correct position?
Engaged?
d
d