Operating The Appliance - Bosch MUM 81 Serie Gebrauchsanleitung

en

Operating the appliance

d Attention!
Do not operate the appliance without an
accessory/tool in the operating position.
The appliance cannot be operated unless
unused drives have been covered with the
drive covers (11, 12, 13). Ensure that the tool
drive cover is attached correctly (Fig. 2a).
Do not operate the appliance empty. Do not
expose appliance or accessories to heat
sources.
S Before using the appliance and accessories
for the first time, clean them thoroughly, see
Cleaning and servicing".
Preparation
S Place the base unit on a smooth and clean
worktop.
S Pull out the power cord (Fig. 3).
If the appliance features an automatic cord
winder:
S Pull out the cord in one go to the required
length (max. 110 cm) and slowly release;
the cord is locked.
S Reducing the cord length:
Pull gently on the cord and allow it to roll
up to the required length. Then gently
pull the cord again and slowly release;
the cable is locked.
S Re insert the mains plug.
d Attention!
Do not twist the cord when inserting it.
If the appliance features an automatic cord
winder, do not insert the cord manually.
If the cord jams, pull out the cord all the way
and then allow it to wind up.
Setting the operating position
S Press the Release button (1) and move the
swivel arm.
S Move the swivel arm until it engages in the
required position.
Selecting the setting
S Rotate the switch (3) to the required setting.
0/off = Stop/Off
M = Pulse switch
Settings 1-4 = Operating speed
10
Fig. 4
Fig. 5
Hold rotary switch.
The drive operates at
maximum speed.
(1 = slow, 4 = fast)
Intermediate settings
are indicated.
Stirrer, whisk, kneading hook
Stirrer (7)
for stirring dough, e.g. cake mixture
Whisk (8)
for whisking egg whites, cream and light
dough, e.g. sponge mixture
Kneading hook (9)
for kneading heavy dough and for folding in
ingredients which are not to be cut (e.g. raisins,
chocolate chips)
Risk of injury from
d
rotating tools
While the appliance is running, keep hands
clear of the bowl. Attach the cover (4) before
operating the appliance!
Do not change tools until the drive has come
to a standstill when the appliance is
switched off, the drive continues running
briefly and stops in the tool change position.
Do not move the swivel arm until the tool has
come to a standstill.
The appliance cannot be operated unless
unused drives have been covered with the
drive covers (11, 12, 13).
Working with the bowl and the tools Fig. 6
S Press the Release button (1) and move the
swivel arm to position 6.
S Depending on the processing task, insert the
stirrer, whisk or kneading hook until it locks
into position.
Note:
After engaging the kneading hook (9),
press the cover over the drive (Fig. 10).
S Insert the bowl:
- Tilt the bowl forwards and then set it down
- Rotate the bowl as far as possible in an
anti clockwise direction
Note:
The recess in the bowl must fit into the
moulded part on the base unit (Fig. 6a).
S Put the ingredients to be processed into
the bowl.
S Press the Release button (1) and move the
swivel arm to position 1.
S Attach the cover.
S Move the rotary switch to the required
setting.
d