Bosch MUM 81 Serie Gebrauchsanleitung Seite 12

en
Our recommendation:
- Stirrer:
first stir in at setting 1, then setting 3 or 4
- Whisk:
setting 4, mix in at setting 1
- Kneading hook:
first stir in at setting 1, knead at setting 2
Adding more ingredients
S Switch off the appliance with the rotary
switch.
S Remove the cover.
S Press the Release button and move the
swivel arm to position 6.
S Add ingredients
or
S Add more ingredients through the feed tube
in the cover.
After work
S Switch off the appliance with the rotary
switch.
S Pull out the mains plug.
S Remove the cover.
Tip: To do this, hold down the release
button (1) and remove the cover.
S Press the Release button and move the
swivel arm to position 6.
S Take the tool out of the drive.
S Remove the bowl.
S Clean all parts, see Cleaning and servicing".
Important information concerning
the use of the whisk
The whisk should almost touch the bottom of
the bowl to ensure that the ingredients are
optimally mixed. If small amounts of ingredients
are to be processed, the whisk should lightly
touch the bottom of the bowl. If not, adjust the
height of the whisk as follows:
S Pull out the mains plug.
S Press the Release button and move the
swivel arm to position 6.
S Insert the whisk into the drive until the whisk
locks into position.
S Hold the whisk and loosen the nut with the
enclosed wrench (wrench on base).
S Set the whisk to the optimum height by
rotating the whisk:
- rotate to left: raise
- rotate to right: lower
S Press the Release button (1) and move the
swivel arm to position 1.
Check the height of the whisk and,
if required, correct.
S When the height has been set correctly,
press Release button (1) and move the
swivel arm to position 6.
S Hold the whisk and tighten the nut with the
enclosed wrench.
Blender
If the blender is not included with your
appliance, you can purchase one as an
optional accessory.
d
Never place hands in the attached blender!
Do not remove/attach the blender until the
drive is at a standstill!
Never operate the blender empty.
Blender will not work unless the cover has
been attached and locked.
d
When blending hot liquids, steam escapes
through the funnel in the cover. Add
maximum 0,5 litres of hot or frothing liquid.
Working with the blender
S Press the Release button (1) and move the
swivel arm to position 3.
S Remove the blender drive cover.
S Drive covers (11 and 12) must be attached.
Ensure that they are attached properly
Fig. 9
(Fig. 2a)!
S Attach the blender (note mark on the
appliance and on the blender) and rotate as
far as possible in an anti clockwise direction.
S Add ingredients.
- Maximum amount of liquid ingredients
= 1.25 litres;
- Maximum amount of frothing or hot liquids
= 0.5 litres;
- Optimum processing amount of solid
ingredients = 150 grams.
S Attach the cover and as far as possible
in a clockwise direction.
The lug on the blender cover must be fully
located in the slot in the blender handle!
S Move the rotary switch to the required
setting.
Risk of injury from sharp
blades/rotating drive
Risk of scalding
d
d
Fig. 7
11