Cleaning And Servicing; Cleaning The Base Unit - Bosch MUM54230 Gebrauchsanleitung

en
Cleaning and servicing
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the continuous­feed shredder in an
anti­clockwise direction and remove.
■ Rotate the lid in an anti­clockwise direction
and remove.
■ Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Fig. H).
■ Clean parts.
Blender
W Risk of injury from sharp blades /
rotating drive!
Never place fingers in the attached blender!
Do not remove / attach the blender until the
drive is at a standstill! Operate the assem­
bled blender only and with the lid attached.
W Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid. Add a
max. 0,5 litres of hot or frothing liquid.
Warning!
Blender may be damaged. Do not process
deep­frozen ingredients (except ice cubes).
Do not operate blender when empty.
Working with the blender
Fig. J:
■ Press the release button and
move the swivel arm to position 4.
■ Remove the blender drive cover.
■ Attach blender jug (mark on the handle on
mark on the base unit) and turn all the way
in an anti­clockwise direction.
■ Add ingredients.
Maximum amount of liquid = 1.25 litres;
maximum amount of frothing or hot liquids
= 0.5 litres;
Optimal processing capacity –
solids = 50­100 g;
■ Attach the cover and turn anti­clockwise all
the way into the blender handle. The cover
must be locked in position.
■ Set the rotary switch to the desired setting.
24
All manuals and user guides at all-guides.com
Adding more ingredients
Fig. J-8:
■ Switch off the appliance with the rotary
■ Remove the lid and add ingredients
or
■ remove the funnel and gradually add solid
or
■ pour liquid ingredients through the funnel.
After using the appliance
■ Switch off the appliance with the rotary
■ Rotate the blender in a clockwise direction
Tip: It is recommended to clean the blender
immediately after use.

Cleaning and servicing

The attachments and accessories used must
be thoroughly cleaned after each use.
Attention!
Do not use abrasive cleaning agents.
Surfaces may be damaged.

Cleaning the base unit

W Danger of electric shock!
Never immerse the base unit in water or
place under running water. Do not use a
steam cleaner.
■ Remove mains plug.
■ Wipe the base unit and drive cover with
■ Then dry the base unit.
Cleaning the bowl and tools
The bowl and tools are dishwasher­proof. Do
not wedge plastic parts in the dishwasher, as
they could be permanently deformed during
the washing process!
switch.
ingredients through the refill opening
switch.
and remove.
a damp cloth. If required, use a little
detergent.