Appendices; Technical Data - Ottobock Avantgarde XXL 2 Gebrauchsanweisung

Inflating
• Check around the tyre on both sides to ensure that the tube is not clamped between the
edge of the tyre and the rim.
• Push the valve back slightly and then pull it out again to ensure that the tyre is properly sea-
ted in the valve area.
• Inflate the tyre until it can still be pressed easily with your thumb. If the control line on both
sides of the tyre is an even distance to the rim, the tyre sits centrally. If the tyre does not sit
centrally, let out some air and realign the tyre. Then inflate the tyre to maximum operating
pressure (see sidewall) and tighten the dust cap.

9 Appendices

9.1 Technical data

INFORMATION
• Many of the technical data below are given in mm. Please note that product settings – unless otherwi-
se specified – cannot be adjusted in the mm range but only in increments of approx. 0.5 cm or 1 cm.
• Note that the values achieved during adjustment may deviate from the values specified below. The
deviation can be ±10 mm and ±2°.
Overall length (in mm)
Lower leg length max./
Seat depth
400
420
440
460
480
Avantgarde XXL 2
62
Rear axle position
min.
550 955
320 895
550 975
320 915
550 995
320 935
550 1015
320 975
550 1035
320 975
24"
Front axle position Rear axle position
850
790
870
810
890
830
910
850
930
870
Appendices
26"
Front axle position
980 875
920 815
1000 895
940 835
1020 915
960 855
1040 935
980 875
1060 955
1000 895
Ottobock | 77
63