Controlling Zone 2/Zone 3 Using The Remote Control - Yamaha RX-V4600 Bedienungsanleitung

Controlling Zone 2/Zone 3 using
the remote control
The supplied remote control can be used to control
Zone 2/Zone 3. You can even select the input source and
control components located in the main room directly
from the second/third room regardless of the listening
condition in the main room.
■ To enable Zone mode on the remote
control
You will be able to switch the remote control mode from
one room to another, and use the input selector,
STANDBY, SYSTEM POWER, MUTE and
VOLUME +/– to control the selected room.
1
Set REC OUT/ZONE 2 on the front panel to
SOURCE/REMOTE.
DVD
DTV
CBL/SAT
VCR 1
DVR/
VCR 2
REC OUT/ZONE 2
2
Repeat steps 1 through 3 of the procedure in
"Setting remote control codes" on page 72.
3
Press l / h to select "L;AMP".
PRESET
ENTER
A/B/C/D/E
4
Press ENTER.
"2000" appears in the display window.
5
Enter the code number "2001" or "2003".
For details, see page 73.
6
Press ENTER to set the number.
"OK" appears in the display window if setting was
successful.
7
Press LEARN to complete the Zone setup.
The remote control will be able to operate this unit
from Zone 2 or Zone 3.
LEARN
SOURCE/
REMOTE
MD/TAPE
CD-R
TUNER
CD
■ To control Zone 2/Zone 3
1
Press SELECT k repeatedly to display
"ZONE 2" or "ZONE 3" in the display window.
2
Press SYSTEM POWER to turn Zone 2 or
Zone 3 power on.
3
Press an input selector button to select the
input source you want to listen to in the
second/third room.
The display window shows "2: name of selected
input" or "3: name of selected input" if the remote
control is in the Zone 2/Zone 3 mode.
A B
PHONO TUNER
V-AUX CBL/SAT
DTV VCR 1
Note
Signals input at V-AUX and PHONO jacks cannot be sent to
Zone 2/Zone 3.
4
You can control the unit from Zone 2 or Zone
3 by using the input selector, STANDBY,
SYSTEM POWER, MUTE and VOLUME +/–
buttons.
SYSTEM
POWER POWER STANDBY POWER
TV AV
A B AUDIO SELECT SLEEP
PHONO TUNER CD MULTI CH IN
V-AUX CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR2 DVD
* VOLUME +/– can be used only when Zone2 Volume or
Zone3 Volume is set to "Variable" in the GUI menu
(see page 68).
ZONE 2/ZONE 3
SELECT
or
AUDIO SELECT SLEEP
CD MULTI CH IN
MD/TAPE CD-R
DVR/VCR2 DVD
SELECT
AMP
+ + +
SOURCE
TV VOL CH VOL
*
– – – TV
TV MUTE TV INPUT MUTE
PRESET
TOP EXIT PURE DIRECT
TITLE MENU
85