Speaker Impedance Setting; Turning On The Power - Yamaha RX-V4600 Bedienungsanleitung

CONNECTIONS

Speaker impedance setting

Follow the procedure below to change the impedance
setting for all speakers.
CAUTION
If you are using 6 ohm speakers, set the impedance to
6 ohms before using this unit.
Be sure this unit is in the standby mode.
1
On the front panel, while holding down
STRAIGHT/EFFECT, press STANDBY/ON.
"SP IMP.–8ΩMIN" appears on the front panel
display.
STRAIGHT
EFFECT
SP IMP.-8 MIN
2
Press STRAIGHT/EFFECT to select the
impedance of your speakers.
If you are using 6 ohm speakers, select 6 ohms; if you
are using 8 ohm speakers, select 8 ohms.
3
Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
Note
Speaker impedance setting function is located in the Advanced
menu (see page 87).
26
STANDBY
/ON

Turning on the power

When all connections are complete, turn on the power of
this unit.
1
AUDIO MULTI CH
SELECT INPUT A/B/C/D/E
INPUT
SPEAKERS
SOURCE/
REMOTE
DVD MD/TAPE
DTV CD-R
A B
CBL/SAT TUNER
STANDBY VCR 1 CD SILENT CINEMA
/ON DVR/
VCR 2
REC OUT/ZONE 2 OPTIMIZER
MIC PHONES
POWER POWER
TV
A
PHONO TUNER
V-AUX CBL/SAT
DTV VCR 1
+
1
Press STANDBY/ON (or SYSTEM POWER on
the remote controls) to turn on the power of
this unit.
STANDBY
/ON
Front panel
2
Turn on the video monitor connected to this
unit.
Note
Press STANDBY/ON again (or STANDBY on the remote
control) to enter the standby mode.
PURE DIRECT
VOLUME
PRESET/ PRESET/ TUNING TONE
TUNING TUNING FM/AM MEMORY MODE STRAIGHT CONTROL
EDIT MAN'L/AUTO FM AUTO/MAN'L EFFECT
ZONE ON/OFF ZONE CONTROL
PROGRAM
MAIN ZONE 2 ZONE 3
S VIDEO VIDEO L AUDIO R OPTICAL
VIDEO/AUX
SYSTEM
STANDBY POWER
1
AV
B AUDIO SELECT SLEEP
CD MULTI CH IN
MD/TAPE CD-R
DVR/VCR2 DVD
SELECT
AMP
+ +
SYSTEM
POWER
or
Remote control