Yamaha RX-V4600 Bedienungsanleitung Seite 109

Problem
The protection circuitry has been activated
The sound suddenly
because of a short circuit, etc.
goes off.
The sleep timer has turned the unit off.
The sound is muted.
Incorrect cable connections.
Only the speaker on
one side can be
heard.
Incorrect balance settings in the GUI
menu.
When playing a monaural source with a
Only the center
CINEMA DSP program, the source signal
speaker outputs
is directed to the center channel, and the
substantial sound.
front and surround speakers output effect
sounds.
The sound field programs are turned off.
No sound from the
effect speakers
You are using a source or program
combination that does not output sound
from all channels.
The output level of the center speaker is
No sound from the
set to minimum.
center speaker
Center is set to "None" in Speaker Set.
One of the HiFi DSP programs (except for
7ch Stereo) has been selected.
The output level of the surround speakers
No sound from the
is set to minimum.
surround speakers
Surround is set to "None" in Speaker Set.
A monaural or stereo source is being
played with STRAIGHT.
Presence speakers are selected.
No sound from the
surround back
Surround is set to "None" in Speaker Set.
speakers
Surround Back is set to "None" in
Speaker Set.
Bass Out is set to "Front" when a Dolby
No sound from the
Digital or DTS signal is being played.
subwoofer
Bass Out is set to "SWFR" or "Front"
when a 2-channel source is being played.
The source does not contain low bass
signals.
Cause
Check that the impedance selector setting is correct.
Check the speaker wires are not touching each other
and then turn this unit back on.
Turn on the power, and play the source again.
Press MUTE to cancel a mute.
Connect the cables properly. If the problem persists,
the cables may be defective.
Adjust the Speaker Level settings.
Press STRAIGHT/EFFECT to turn them on.
Try another sound field program.
Raise the level of the center speaker.
Select the appropriate setting for the center speaker.
Try another sound field program.
Raise the output level of the surround speakers.
Select the appropriate setting for the surround left and
right speakers.
Press STRAIGHT/EFFECT to turn on the sound
fields.
Select "Surround Back" in PR/SB Select.
If the surround left and right speakers are set to
"None", surround back speakers are automatically set
to "None". Select the appropriate setting for the
surround left and right speakers.
Select "Small x1", "Small x2", "Large x1" or
"Large x2".
Select "SWFR" or "Both".
Select "Both".
TROUBLESHOOTING
Remedy
Refer to
page
26
—
—
35
18
66
39
34
66
63
34
63
63
—
62
63
64
64
64
107