Confirming The Results - Yamaha RX-V4600 Bedienungsanleitung

AUTO SETUP

Confirming the results

You can confirm the results of each analysis.
If you set Setup Type to "Auto"
The results are displayed after all items have been
analyzed.
Setup Menu
Setup Type
Start
• Press n and select Setup to set the measured values.
• Press k and select Retry to retry the auto setup procedure.
• Press h and select Detail to view information about
measurement results and warning messages. For more
details about warning messages, see "Troubleshooting for
the auto setup procedure" on page 31.
• Press l and select Exit to exit from the auto setup
procedure. If you select Exit, "Don't Setup?" appears on
the screen. To set the measured values and exit, select Yes.
To cancel the settings and exit, select No.
30
Retry
Exit Detail
Setup
Measurement Over
Successfully
If you set Setup Type to "Step"
The results are displayed individually after each analysis.
Distance
Size
Equalizing
Level
Result
• Press n and select Next to start measurement of the next
menu item.
• Press k and select Retry to retry the auto setup procedure.
• Press h and select Detail to view information about
measurement results and warning messages. For more
details about warning messages, see "Troubleshooting for
the auto setup procedure" on page 31.
• Press l and select Exit to exit from the auto setup
procedure. If you select Exit, "Don't Setup?" appears on
the screen. To set the measured values and exit, select Yes.
To cancel the settings and exit, select No.
After all menu items have been measured, "Measurement
Over" appears on the screen and the results for each item
are displayed.
• Press n and select Setup to set the measured values.
• Press k and select Retry to retry the auto setup procedure.
• Press h and select Detail to view information about
measurement results and warning messages. For more
details about warning messages, see "Troubleshooting for
the auto setup procedure" on page 31.
• Press l and select Exit to exit from the auto setup
procedure. If you select Exit, "Don't Setup?" appears on
the screen. To set the measured values and exit, select Yes.
To cancel the settings and exit, select No.
y
If you want to make more detailed settings, change the system
parameters using the Manual Setup menu. If you want to return to
the Auto Setup settings after making settings in the Manual Setup
menu, navigate to the Information screen in the Auto Setup menu,
press k / n repeatedly to select the parameter you want to adjust,
then press ENTER.
Notes
• If you change speakers, speaker positions, or the layout of your
listening environment, perform auto setup again to re-calibrate
your system.
• Depending on your listening environment, SubWfr:REV may
appear in the Wiring results. In this case, SWFR Phase in the
Manual Setup menu (see page 65) is automatically set to
Reverse. To select the desired setting, change the SWFR Phase
parameter in the Manual Setup menu.
• In the Distance results, the distance displayed may be longer
than the actual distance depending on the characteristics of your
subwoofer. This may also be the case when using an external
amplifier.
• In the Equalizing results, different values may be set for the
same band to provide finer adjustments.
Retry
Exit Detail
Next