Yamaha RX-V4600 Bedienungsanleitung Seite 8

CONTROLS AND FUNCTIONS
B STRAIGHT/EFFECT
Switches the sound fields off or on. When STRAIGHT is
selected, input signals (2-channel or multi-channel) are
output directly from their respective speakers without
effect processing.
C Remote control sensor
Receives signals from the remote controls.
D TONE CONTROL
Use to adjust the bass/treble balance for the front left/right
and center channels (see page 35).
E PURE DIRECT
Turns on or off the PURE DIRECT mode. Lights up when
turned on (see page 38).
F REC OUT/ZONE 2
Selects the source you want to direct to the audio/video
recorder and ZONE 2 outputs independently of the source
you are listening to or watching in the main room. When
set to the SOURCE/REMOTE position, the input source is
directed to all outputs. The source in Zone 2 and the
source you record are always identical.
G OPTIMIZER MIC jack
Use to connect and input audio signals from the supplied
microphone for use with the AUTO SETUP function
(see page 27).
H SPEAKERS A/B
Turn on or off the set of front speakers connected to the
A and/or B terminals on the rear panel each time the
corresponding button is pressed.
I
PHONES (SILENT CINEMA) jack
Outputs audio signals for private listening with
headphones. When you connect headphones, no signals
are output at the PRE OUT jacks or to the speakers.
All Dolby Digital and DTS audio signals are mixed down
to the front left and right channels.
J VIDEO AUX jacks
Input audio and video signals from an external source
such as a game console. To reproduce source signals at
these jacks, select V-AUX as the input source.
K ZONE ON/OFF
MAIN
Turns on the power of the main unit or sets it to the
standby mode (see page 84).
ZONE 2
Turns on the power of Zone 2 or sets it to the standby
mode (see page 84).
ZONE 3
Turns on the power of Zone 3 or sets it to the standby
mode (see page 84).
6
L ZONE CONTROL
Press to control the input or adjust the volume level for the
currently selected zone (the main unit, Zone 2 or Zone 3)
(see page 84). After you press ZONE CONTROL, the
indicator for the currently selected zone flashes in the
front panel display for approximately 5 seconds. While the
indicator is flashing, perform the desired operation.
M PROGRAM selector
Use to select sound field programs or adjust bass/treble
balance (in conjunction with TONE CONTROL).
N VOLUME
Controls the output level of all audio channels.
This does not affect the REC OUT level.
■ Opening and closing the front panel
door
When you want to use the controls behind the front panel
door, open the door by gently pressing on the lower part of
the panel. Keep the door closed when not using these
controls.
To open, press gently on the lower part of the panel.