Controlling Zone 2/Zone 3 From The Front Panel - Yamaha RX-V4600 Bedienungsanleitung

ZONE 2/ZONE 3
Using this unit's internal amplifier
To use this unit's internal amplifier, select "Internal" in Zone2 Amplifier 2 (page 68).
Controlling Zone 2/Zone 3 from the
front panel
You can control the input or adjust the volume level for
Zone 2 and Zone 3 components using ZONE CONTROL
on the front panel.
1
Set REC OUT/ZONE 2 on the front panel to
SOURCE/REMOTE.
DTV
CBL/SAT
VCR 1
DVR/
VCR 2
REC OUT/ZONE 2
2
Press MAIN, ZONE 2 or ZONE 3 to select the
zone you want to change the input for or
adjust the volume level.
ZONE ON/OFF
MAIN
Press each button repeatedly to turn the respective
zone on or off.
You can choose from the following modes:
Controls the Zone 2 component
ZONE2
connected to the ZONE 2 AUDIO L/R
jacks on this unit.
Controls the Zone 3 component
ZONE3
connected to the ZONE 3 AUDIO L/R
jacks on this unit.
Controls the main component
MAIN
(this unit).
84
R L
+
–
PRESENCE/ ZONE 2
This unit
SOURCE/
REMOTE
DVD MD/TAPE
CD-R
TUNER
CD
ZONE 2 ZONE 3
Second room
3
Press ZONE CONTROL on the front panel
repeatedly to choose the zone you selected
in step 2.
Each time you press ZONE CONTROL, the front
panel display changes as shown below, and the
indicator for the currently selected zone flashes for
approximately 5 seconds.
ZONE 2
y
• You must complete this step within 5 seconds of pressing
ZONE CONTROL on the front panel. Otherwise, the zone
mode selection process is automatically canceled.
In this case, press ZONE CONTROL again.
• The initial setting is "ZONE 2" when both the Zone 2 and
Zone 3 components connected to this unit are turned on.
• If you selected MAIN in step 2, no indicator flashes on the
front panel display when ZONE CONTROL is pressed.
4
Use the INPUT or VOLUME selector on the
front panel to switch the input or adjust the
volume level for the selected zone
component.
INPUT
y
You must complete this step within 5 seconds of performing
step 2. Otherwise, the zone mode selection process is
automatically canceled. In this case, repeat steps 2 and 3
again.
ZONE CONTROL
ZONE 3
MAIN
VOLUME
or