Connecting The Power Cable; Connecting The Ac Power Cable - Yamaha RX-V4600 Bedienungsanleitung

CONNECTIONS

Connecting the power cable

■ Connecting the AC power cable

Plug the power cable into the AC inlet after all other
connections are complete, then plug the power cable to an
AC IN
AC wall outlet.
CAUTION
Do not use other AC power cables. Use the provided
cable. Use of other power cables may result in fire hazard
or electrical shock.
AC OUTLETS
SWITCHED
■ AC OUTLET(S) (SWITCHED)
U.K. and Australia models ..................................... 1 outlet
Korea model ............................................................... None
Other models ......................................................... 2 outlets
Use these outlets to connect the power cables from your
other components to this unit. Power to the AC
OUTLET(S) is controlled by this unit's STANDBY/ON
(or SYSTEM POWER and STANDBY). These outlets
will supply power to any connected component whenever
(U.S.A. model)
this unit is turned on. The maximum power (total power
consumption of components) that can be connected to the
AC OUTLET(S) is:
Asia and General models .......................................... 50 W
Other models ...........................................................100 W
VOLTAGE SELECTOR
■ VOLTAGE SELECTOR
(Asia and General models only)
The VOLTAGE SELECTOR on the rear panel of this unit
must be set for your local main voltage BEFORE plugging
into the AC main supply. Voltages are:
General model .......AC 110/120/220/230–240 V, 50/60 Hz
Asia model ...........................AC 220/230–240V, 50/60 Hz
■ Memory back-up
The memory back-up circuit prevents the stored data from
being lost even if this unit is in the standby mode.
However if the power cable is disconnected from the AC
wall outlet, or the power supply is cut for more than one
week, the stored data will be lost.
(Asia and General models)
25