Changing The Prosthesis Setting Using The Cockpit App; Overview Of Adjustment Parameters In Basic Mode - Ottobock Genium X3 3B5-3 Gebrauchsanweisung

Information for changing the prosthesis settings
• Before changing settings, always check the main menu of the Cockpit app to make sure the
correct component has been selected. Otherwise parameters could be changed for the
wrong component.
• It is not possible to change prosthesis settings nor to switch to a different mode while the
prosthesis battery is being charged. Only the status of the prosthesis can be called up.
Instead of the
pit app.
• The O&P professional's setting is located in the middle of the scale. After making adjust­
ments, this setting can be restored by tapping the "Standard" button in the Cockpit app.
• Prosthesis settings should be optimised using the adjustment software. The Cockpit app is
not intended for use by the O&P professional to set up the prosthesis. The everyday behaviour
of the prosthesis can be changed to a certain extent using the app (e.g. while becoming
accustomed to the prosthesis). The O&P professional can use the adjustment software to
trace these changes at the next appointment.
• If the settings of a MyMode are to be modified, one must first switch to this MyMode.

8.2.1 Changing the prosthesis setting using the cockpit app

Product
MyModes
Functions
Settings
Status
General
Manage components
Imprint/Info

8.2.2 Overview of adjustment parameters in basic mode

INFORMATION
When mute mode (silent mode) is activated, no beep and vibration signals are generated.
The parameters in basic mode describe the dynamic behaviour of the prosthesis in a normal gait
cycle. These parameters act as basic settings for automatically adjusting the damping behaviour
to the current motion situation (e.g. ramps, slow walking speed, etc.).
The stance function, sitting function and/or stairs and obstacles function can also be activ­
ated/deactivated. Further information on the stance function (see Page 74), sitting function (see
Page 75), stairs and obstacles function (see Page 76).
78
symbol, the symbol appears in the bottom row of the screen in the cock­
1) Once the component is connected and in the desired mode,
tap the symbol in the main menu.
→ The navigation menu opens.
2) Tap the menu entry "Settings".
change
→ A list appears with the parameters for the currently
2. Golf
3) Change the setting of the desired parameter by tapping the
"<", ">" symbols.
INFORMATION: The prosthetist's setting is marked
and, after the setting has been changed, can be
restored by tapping the "Standard" button.
selected mode.