Installation In The Modular Prosthesis - Ottobock 4R118 Gebrauchsanweisung

► Observe the alignment and assembly instructions.
5.1 Preparing the prosthetic socket
The distal end of the prosthetic socket is ground to ensure full-surface con­
tact of the adapter plate.
► NOTICE! Grind parallel to the distal surface of the socket attach­
ment block to avoid damage to the load-bearing structures.
Sand down the excess laminate on the distal end of the prosthetic sock­
et.

5.2 Installation in the modular prosthesis

CAUTION
Improper assembly of the screw connections
Fall due to breakage or loosening of the screw connections
► Clean the threads before every installation.
► Apply the specified installation torque values.
► Observe the instructions for securing the screw connections and the
use of the correct length.
Mounting on socket attachment block
Recommended tools:
>
710D4 torque wrench, 636K13 Loctite®
1) Select the correct cap screws for the socket attachment block or the
lamination disc (see selection table).
2) Position the adapter plate with the slotted holes on the socket attach­
ment block or the lamination disc.
3) Adjust the desired posterior displacement.
4) Apply Loctite® to the cap screws, slide them through the slotted holes
and tighten them crosswise (torque value 10 Nm).
Socket attachment block, lamination
disk
5R2
5R1=1, 5R1=2, 5R1=6
5R6=1, 5R6=2, 5R6=3
12 | Ottobock
Cap screw
501T61=M6x12
501T61=M6x25
501T61=M6x30