System Compatibility - Honeywell MILLER TURBOLITE EDGE Gebrauchsanweisung

on a regular basis, at least annually.
Any product exhibiting deformities, unusual wear, or deterioration must be immediately
discarded in such a manner as to prevent inadvertent further use.
Any equipment subject to a fall must be removed from service.
The authorized person/user shall have a rescue plan and the means at hand to implement it
when using this equipment.
Equipment must not be altered in any way. Do not lubricate or attempt to repair this device.
Repairs must be performed only by the manufacturer, or persons or entities authorized in
writing by the manufacturer.
Never use fall protection equipment for purposes other than those for which it was designed.
Fall protection equipment should never be used for towing or hoisting.
Environmental hazards should be considered when selecting fall protection equipment.
Equipment must not be exposed to chemicals, heat, flames, or other environmental condi-
tions which may produce a harmful effect. Polyester should be used in certain chemical or
acidic environments. Use in a corrosive or caustic environment dictates a more frequent
inspection and servicing program to ensure the integrity of the device is maintained.
All synthetic material must be protected from slag, hot sparks, open flames, or other heat
sources. The use of heat resistant materials is recommended in these applications.
Do not allow equipment to come in contact with anything that will damage it including, but
not limited to, abrasive, rough or high-temperature surfaces, heat sources, electrical haz-
ards, or moving machinery.
Do not expose the equipment to any hazard which it is not designed to withstand. Consult
the manufacturer in cases of doubt.
Never remove product labels, which include important warnings and information for the
authorized person/user.
Warning
Always refer to the regulations and standards regarding personal fall arrest system com-
ponent requirements and the instructions provided with each component being used as
part of the personal fall arrest system.
IF THE PRODUCT IS SOLD OUTSIDE THE FIRST COUNTRY OF DESTINATION, FOR THE
SAFETY OF THE USER, THE DEALER MUST ENSURE THAT THE PRODUCT IS COMPLI-
ANT WITH THE LAWS APPLICABLE IN THAT COUNTRY AND PROVIDE INSTRUCTIONS
FOR THE PRODUCT IN THE APPROPRIATE LANGUAGE, COVERING ALL THE REQUIRE-
MENTS OF THE EN 360 STANDARD AND APPLICABLE LAWS.
3.1 Warnings and Limitations
For use by ONE person only.
clothing and tools.

System Compatibility

Honeywell Miller fall protection products are designed for use with Honeywell-approved
components only. Substitution or replacement with non-approved component combina-
tions or subsystems or both may affect or interfere with the safe function of each other and
endanger the compatibility within the system. This incompatibility may affect the reliability
and safety of the total system.
Anchorage Requirements
The anchorage must be capable of supporting 12kN (e.g. EN795 anchor device) per worker;
or it must be designed, installed, and used under the supervision of a qualified person as
part of a complete fall arrest system which maintains a safety factor of two.
Harness
A fall-arrest harness must be the only appropriate device for holding the body used with this
fall arrest system. It must comply with EN 361. For example, the TurboLite Edge CE Personal
Fall Limiters are designed for use in combination with Honeywell Miller harnesses: Miller
Revo comfort R2, Miller H-Design, Miller H-Design Hi vest, Miller H-Design Quick Fit Vest +
Titan Harness, Miller Revolution Premium R5, Miller H-Design BodyFit & BodyFix Harness or
harnesses with similar design.
Max. user weight load limit is 140kg, including body weight,
15