Operation; A) Removing The Vehicle Body; B) Installation Of Receiver Aerial Cable; C) Inserting The Battery Pack Into The Vehicle - Reely Massive Bedienungsanleitung



9. Operation

a) Removing the vehicle body

The vehicle body is secured at the chassis with holding clips which must be pulled out from the retaining pins. The
vehicle body can then be taken off.

b) Installation of receiver aerial cable

The receiver aerial cable is normally rolled up on delivery. Unroll the aerial cable completely and smoothen it carefully.
Run the aerial cable through the aerial tube and stick the aerial tube into the aerial mount on the vehicle.
A rubber cap might be enclosed for the aerial tube. Place it on the tip of the aerial tube to prevent the cable from
moving out of position.
Make sure the aerial cable does not get into the drive mechanism.
Never shorten the aerial cable, which would reduce the range. Do not coil up the cable if it does not fit
into the aerial tube! Just let it hang loose from the top of the aerial tube.

c) Inserting the battery pack into the vehicle

Caution!
The battery pack must not be connected to the speed controller yet!
A conventional 6-cell racing pack (NiCd or NiMH) is required for the vehicle. The battery pack is fastened with a plastic
bar that is secured with two holding brackets.
When inserting the battery pack, make sure that the battery cable cannot get caught up in the steering mechanism or
the drive.

d) Inserting batteries/rechargeable batteries into the remote control

If you have not already done so, insert batteries/rechargeable batteries into the remote control. Observe the correct
polarity (positive/+ and negative/-) as indicated in the battery compartment of the remote control. To open the battery
compartment, slide the lid forward and take it off.
32