Gastroback DESIGN TEE AUTOMAT ADVANCED PLUS Bedienungsanleitung Seite 108

Problem
You started the hot water
program via the WATER
button, but the time dura-
tion until boiling is unusual
long, or the water is not
boiling at all.
EN
108
Reason
You left the water or tea
in the kettle for too long.
Excessive deposits of lime
in the kettle.
The interior of the kettle
is coated with residues
of tea, causing a unusual
taste, when heating clear
water.
The water temperature
has been set below
95-100°C (203-212°F).
The appliance switched to
keep warm already, the
keep warm indicator is
illuminated.
Excessive amounts of lime
cover the heating plate.
Malfunction occurred.
The Solution
Always empty the kettle completely after usage and,
in any case, rinse the kettle thoroughly with clear tap
water, before standing the kettle aside. However, after
preparing tea, it is better to clean the kettle thoroughly
after each usage (see: 'Care and Cleaning').
Descale the kettle in time (see: 'Care and Cleaning /
Descaling the Kettle'). Excessive deposits of lime could
even damage the kettle.
At least, after using the appliance for making tea, you
should clean the kettle and lid set (see: 'Care and Clea-
ning'). This is required in any case, if you wish to heat
clear water for other beverages.
Before starting operation, ensure that the desired tem-
perature is shown on the display. If required, adjust the
temperature accordingly (see: 'Operation / Selecting or
Setting Up a Program').
The maximum keep warm temperature is limited to
90°C. This is normal. If boiling water is required, cancel
the running program and start it again with the tempera-
ture set to 100°C (212°F).
Descale the kettle in time (see: 'Care and Cleaning /
Descaling the Kettle'). Excessive deposits of lime could
damage the kettle.
Cancel the running program and unplug the appliance.
Wait for 15 minutes. Then try again. If the problem
persist, contact the Gastroback Customer Care Center by
phone: +49 (0)4165/22 25-0 or e-mail info@gastro-
back.de.