Selecting Or Setting Up A Program - Gastroback DESIGN TEE AUTOMAT ADVANCED PLUS Bedienungsanleitung

ween the lid ring and kettle. If required, turn the lid ring until the pouring sieve
is placed at the spout of the kettle. Push the lid ring down without violence. Fill
the required amount of clear drinking water into the kettle. For operation, at least
fill in 500ml of clear drinking water ("0.5L / MIN"). If you wish to make tea,
do not fill in more than 1200ml ("1.2L / MAX TEA"). If you wish to heat clear
water, you may fill the kettle with up to 1500ml ("1.5L / MAX WATER").
NOTE
When filling in more than 1200ml for making tea, the ingredients of your tea will
not be kept above the water level until the water is heated and after steeping.
Therefore, your tea may get an undesired taste and flavour. However, some types
of herbs demand heating up slowly within the water. In this case, you may use
1400ml water for your tea and manually push the tea infuser down via the pusher
after inserting the filled filter system and before starting the appliance. Then remove
the filter system immediately after steeping.
IMPORTANT - Always keep the kettle level, when it is filled. During filling the kettle,
ensure not to spill water on the exterior of the kettle. If required, wipe dry the exte-
rior of the kettle, before placing the kettle onto the power base.
5. Heating Water: Close the kettle via the lid (see: 'Heating Clear Water').
6. Making Tea: When inserting the prepared filter system, hold the filter system by
the pusher rod to avoid that the tea infuser falls into the water (see: 'Preparing
the Filter System'). Insert the tea infuser into the kettle and press the magnet holder
into the lid ring. Ensure that the tea infuser is held by the magnet holder when
releasing the pusher rod.
7. Ensure that the exterior of the kettle is clean and dry. Then place the kettle onto
the power base. The appliance is now ready for operation (standby mode).
8. Select the desired program (see: 'Selecting or Setting Up a Program' or 'Heating
Clear Water').

SELECTING OR SETTING UP A PROGRAM

9. Select the desired program (see: 'Properties of Your New Tea Maker / Recom-
mended Usage of the Programs').
Heating water to the boil: For this purpose, you do not need to select a program.
However, you can adjust the desired temperature (see below: 'Heating Clear Water').
Selecting a pre-defined tea program: Press the selection buttons + or – until the
desired program is shown on the display.
EN
94