Gastroback DESIGN TEE AUTOMAT ADVANCED PLUS Bedienungsanleitung Seite 89

2 Before first use and after an elongated period of storage, clean all parts of the
appliance (see: 'Care and Cleaning'). Rinse the interior of the kettle thoroughly
with clear tap water. Completely unwind the power cord and insert the power
cord into the cord groove at the bottom of the power base. Select a suitable
place for operating the appliance near a sufficient wall power outlet. Leave a
distance of at least 20 cm to the edge of the table or counter and to any other
object (see: 'General Safety Instructions').
3. Remove the kettle from the power base and fill the kettle with 1500ml ("1.5L
MAX WATER") of clear tap water. Close the kettle via the lid ring and lid and
place the kettle onto the power base (see: 'Operation / Preparing the Appliance
for Operation').
IMPORTANT - When connecting the appliance to the power supply, an initialisa-
tion is performed and the cantilever may be moved automatically. This movement
is required for ensuring correct operation of the motor drive. Thus, when plugging
in the appliance, there may be no foreign objects obstructing the movement of the
cantilever. Also, ensure that there are no stickers or promotion labels at the pillar.
However, for initialisation, it is not essential, whether the kettle is placed on the
power base and whether the filter system is installed or not.
4. Ensure, that there are no obstacles blocking the cantilever or pillar. Connect the
power plug directly to a suitable wall power outlet and wait until the display
illuminates.
5. Press the TEMP/TIME button to make the temperature flash on the display. Press
the selection button + until 100 is displayed.
6. Press the WATER button. The WATER button illuminates. Wait until the water
is boiling vigorously and the signal sounds (see: 'Operation / Heating Clear
Water').
7. Press the WATER button again. Thereafter discard the water and wait until the
kettle cooled down (mind. 15 minutes).
CAUTION
– Do not fill cold water into the kettle, while the kettle is still hot.
Always leave the kettle cool down until it is lukewarm at the maximum. Otherwise,
the glass could crack!
EN
89