Herunterladen Inhalt Inhalt Diese Seite drucken

Operation - Gastroback DESIGN TEE AUTOMAT ADVANCED PLUS Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für DESIGN TEE AUTOMAT ADVANCED PLUS:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

OPERATION

WARNING
sories are out of reach of young children and animals. Do not expose the kettle
to extreme temperature variations (e.g. by pouring cold water onto the glass
body of the hot kettle). The kettle could break, crack, or get chipped, when
handled carelessly. Even small splinters and shards could cause severe injuries
when getting into your food and beverages. Thus, always handle glass parts with
special care to avoid injuries and damage. Do not use any glass parts any longer,
when these parts are broken, cracked, or chipped in any way.
If water runs out during operation, immediately unplug the appliance (see: 'Solving
Problems').
Hot water and steam could cause severe scalds. Always keep the kettle level, and
ensure that the kettle will not fall or fall over. During operation and some time there-
after, even the exterior of the kettle, the lid set, and filter system may get hot; only
touch these parts by the handles. When removing the lid or filter system, and/or
during pouring, and even with the lid closed correctly, hot steam and condensate
could escape. If required, protect you hands.
Always remove the kettle from the base for removing the filter system or lid. Do not
obstruct the movements of the cantilever. Do not move the cantilever manually. The
appliance is suited for partly unattended operation. However, do not leave the
power base connected to the power supply, when it is not in use. Do not leave the
appliance operate unattended, when intervention in the case of any danger or
hazard is impossible, or when young children or animals may get access to the
appliance! To avoid overheating, before operation, always fill at least 500ml ("0.5L
/ MIN") of clear drinking water into the kettle. Do not operate the appliance with
the water level below the minimum filling level (250ml; approx. 1cm above the
tip of the temperature probe). Do not fill in more than the maximum amount (1500ml;
"1.5L / MAX WATER"). If the kettle is overfilled, boiling water may splash. Regularly
descale the kettle (see: 'Care and Cleaning').
IMPORTANT - For operation, always place the lid ring on top of the kettle. Then
close the kettle via the lid (heating water) or filter system (making tea). With the
kettle left open, the temperature control will not operate correctly, because of high
energy loss.
NOTE
Any program can be cancelled at any time (see: 'Cancelling Operation').
EN
92
– Always ensure that the appliance and all its parts and acces-

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis