Gastroback DESIGN TEE AUTOMAT ADVANCED PLUS Bedienungsanleitung Seite 107

Problem
You cannot start the
desired program.
Water accumulates under
the power base or runs
down on the exterior of
the kettle.
Immediately unplug
the appliance and wipe
dry the appliance com-
pletely.
The water has an
unpleasant taste.
Reason
The appliance is not live.
The kettle is not placed on
the power base correctly.
"E3" is displayed.
The set temperature is
lower than or equal to the
current water temperature
within the kettle. "E1" is
displayed.
The boil dry protection has
been triggered. "E2" is
shown on the display.
There is too much water
in the kettle. At the spout,
the water is boiling out of
the kettle.
You spilled some water
during filling or moving
the kettle.
The kettle is not closed
correctly during operation.
Boiling water is splashing.
The kettle is leaking.
This may happen on new
appliances or appliances
that are used only rarely.
The Solution
Check, whether the power outlet is live.
Fill the kettle with at least 0.5 litres of water and place
the kettle on the power base. If required, turn the kettle
on the power base. Then try again.
The set temperature must be higher than the current tem-
perature within the kettle to start a program. Wait until
the kettle cooled down sufficiently, select a somewhat
higher temperature, or carefully and slowly pour some
cold water into the centre of the kettle (see: 'Operation
/ Adding Water during Operation').
Unplug the appliance, empty the kettle, and leave the
kettle cool down for at least 30 minutes (see: 'Properties
of Your New Tea Maker / Boil Dry Protection'). There-
after, fill the kettle with at least 0.5 litres (500ml) of
cold water and try again.
Leave the appliance dry naturally for at least 1 day.
Always observe the maximum filling level when filling
(see: 'Technical Specifications').
Ensure not to spill water on the exterior of the kettle duri-
ng filling. Always ensure to hold the kettle level, when
it is filled.
Always ensure to close the kettle correctly via the lid ring
and filter system or lid, before starting a program.
Check the kettle for leakage. For this, place the filled
kettle on a dry surface for some hours. Do not use the
appliance, when the kettle is leaking. If required, contact
your vendor.
Prepare the appliance for usage as described in chapter
'Before First Use'. If the problem persists, fill the kettle
with 1500ml of water and add two teaspoons of baking
soda. Select 100°C and press the WATER button. Leave
the appliance operate until automatic shut-off (see: 'Ope-
ration / Heating Clear Water'). Then discard the water
and clean the kettle thoroughly.
EN
107