Gastroback DESIGN TEE AUTOMAT ADVANCED PLUS Bedienungsanleitung Seite 97

NOTE
You may cancel any running program at any time by simply pressing the illumina-
ted start/stop button (TEA or WATER). If required, the cantilever moves up immedi-
ately. The start/stop button gets dark and the appliance returns to standby mode.
WARNING
hot steam and condensate may escape from under the lid. This holds especially
when removing the filter system or lid. Additionally, the lid and filter system may
be hot. Only touch the lid and filter system by the handle or pusher plate and be
aware of hot steam and condensate, when removing the lid or filter system. If
required, protect your hands.
16. Wait until the signal sounds, indicating that the set steeping time elapsed. The
cantilever lifts the tea infuser out of the water and the magnet holder keeps the
tea infuser in the upper position.
Thereafter, "BASKET" is shown on the display. In any case (even with the keep warm
function deactivated) the tea will be kept warm for 5 minutes.
NOTE
If you wish to get your tea somewhat darker after steeping, with the cantilever
being rigid in the topmost position and "BASKET" on the display, you may immerse
the tea infuser manually for some additional seconds.
17. While "BASKET" is displayed, the appliance waits for you to remove the kettle
from the power base and replace the filter system by the lid. When you failed
to remove the kettle within 5 minutes, the appliance switches off completely
and the operating elements get dark.
With the keep warm function activated: when the kettle is removed shortly, while
"BASKET" is still shown, the appliance enters normal operation of the keep warm
function (see: 'Properties of Your New Tea Maker / Keep Warm Function').
IMPORTANT - Ensure that the lid ring and lid are installed correctly on the kettle,
before pouring. Otherwise the lid set could fall.
– When operating the appliance at high water temperature,
EN
97