Preparing The Filter System; Preparing The Appliance For Operation - Gastroback DESIGN TEE AUTOMAT ADVANCED PLUS Bedienungsanleitung

PREPARING THE FILTER SYSTEM

For automatic, program-controlled tea making, the filter system (tea infuser and
Infuser cover with magnet holder and pusher) must be used. Automatic steeping is
impossible with any other tea infuser system.
NOTE
Adapt the amount of tea leaves to your liking. We recommend to start with 5 to
7 g tea leaves (approx. 2 heaped teaspoons) for each 500ml of water. Please,
leave some free space within the tea infuser to allow swelling of the ingredients.
Hints for the correct dosage may be given on the tea pack or in specialized tea
shops. Place the tea infuser on a stable surface and fill the tea infuser with the
ingredients of your tea.
When using tea bags, pull out the thread and place the tea bags into the infuser.
You should activate the Auto Steep Function.
You may hang tea bags directly into the kettle via the thread. In this case, the filter
system is not required. We recommend to use the WATER function (see: 'Heating
Clear Water'), because automatic extraction is impossible with this method.
2. Close the tea infuser via the Infuser cover. Press the Infuser cover down until it
snaps into place securely. Ensure that the Infuser cover is not tilted, to avoid that
the tea Infuser could fall off during operation. The filter system is ready for use
now.

PREPARING THE APPLIANCE FOR OPERATION

NOTE
After preparing another type of tea, you should wash the interior of the kettle,
before operation. Otherwise, residues of flavour may influence your tea, especial-
ly when very aromatic types of tea have been made before (e.g. mint or fruit).
1. Completely unwind the power cord and place the power base on the designa-
ted working place near an appropriate wall power outlet (see: 'General Safe-
ty Instructions' and 'Important Safeguards for Electrical Appliances'). Insert the
power plug into the power outlet. An acoustic signal sounds and the cantilever
may move. Wait until the display illuminates with the default settings („75°C
3:00 / GREEN").
2. Remove the kettle from the power base and remove the lid or filter system from
the kettle by pulling it upwards.
3 Ensure that the lid ring is placed correctly on the kettle without any gab bet-
EN
93