Gastroback DESIGN TEE AUTOMAT ADVANCED PLUS Bedienungsanleitung Seite 96

NOTE
When using tea bags, you may use the tea maker without the filter system. In this
case, you should use the WATER function (see: 'Heating Clear Water'). However,
it is better to use the provided filter system and place your tea bags (without thread
and label) into the tea infuser of the appliance and benefit from the special func-
tions of the appliance (see: 'Preparing the Filter System').
NOTE
To reduce energy consumption, do not leave the appliance in keep warm mode
uselessly. The maximum temperature of the keep warm function is limited to 90°C
with the maximum keep warm time selected via the settings menu (see: 'Prefe-
rences').
We recommend to hold the stainless steel coaster provided with the appliance at
hand. Place the tea bags or tea infuser on it after steeping. This will keep your wor-
king space clean and dry. However, you may use any other suitably large coaster
or vessel.
12. Prepare the filter system (see: 'Preparing the Filter System').
13. Prepare the appliance for operation (see: 'Preparing the Appliance for Operati-
on'). When connecting the appliance to the power supply, the pre-defined tea
program "GREEN" with the pre-defined values is always selected.
14. Check the operating elements (display and buttons) against the desired settings.
If required, make your changes (see: 'Selecting or Setting Up a Program').
NOTE
When removing the kettle from the power base during heating, the program is
cancelled automatically. The appliance switches back to standby mode with the
recently used program selected. You can start the program again immediately by
simply pressing the TEA button again. However, after cancelling a tea program
check the values shown on the display, before starting the program again.
IMPORTANT - Avoid moving the cantilever manually. Ensure that the cantilever can
move up and down freely during the extraction.
15. Press the TEA button. The TEA button illuminates and the kettle starts heating.
The actual temperature within the kettle appears on the display with a rising
bar. When the set temperature is reached, an acoustic signal sounds and the
appliance lowers the tea infuser into the water automatically. You do not need
to do anything. Using automatic steeping (AUTO STEEP button is illuminated):
the cantilever moves the tea infuser in and out of the water repeatedly.
EN
96