Gastroback DESIGN TEE AUTOMAT ADVANCED PLUS Bedienungsanleitung Seite 72

immediately in case of any malfunction or danger.
• The pins of the power plug and the power connectors in the power
base and bottom of the kettle must be smooth and clean without dis-
colourations. Keep the power connectors (kettle, power base, and
power cord) always completely dry. Do not poke in the power con-
nectors. Do not attempt to operate the appliance with the power
connectors damaged or polluted in any way to avoid risk of over-
heating, fire, and electric shock.
• Always unwind the power cord completely for operation to avo-
id hazard of overheating, fire and electric shock. Always handle
power cords with care. Do not place the appliance on a power
cord. Power cords may never be knotted, twisted, pulled, strained, or
squeezed. Do not let the plug or power cord hang over the edge of
the table or counter. The power cord may never touch hot surfaces,
sharp edges, or any moving parts. Ensure that no one will pull the
appliance by the power cord. Take care not to entangle in the power
cord. Always grasp the plug to disconnect the power cord. Do not
touch the appliance or power plug with wet hands, while the appli-
ance is connected to the power supply.
• Do not place or immerse the power base, kettle or power cord in water
or any other liquid. DO NOT spill or drip any liquids on the power
base or the power cord or on the exterior of the kettle to avoid risk of
fire and electric shock. If liquids run out or are spilled onto the exterior
of the power base or kettle, do not touch the appliance but immediate-
ly unplug the appliance. Always wipe off spilled liquids immediately. If
in doubt, check the kettle for leakage, before operating the appliance
again. When parts of the appliance are leaking during operation and/
or liquids accumulate under the power base or run down on the exterior
of the appliance or any part of it, immediately unplug the appliance.
Refer to the instructions in chapter 'Solving Problems'.
• Do not place the power base or kettle in an automatic dishwasher.
Do not place the power base on a metal surface, or in a large bowl
or tray for operation. If water is spilled or runs out and accumu-
lates, there would be severe risk of short-cut, electric shock, and
fire. The kettle should NOT be filled, while standing on its power
EN
72