Gastroback DESIGN TEE AUTOMAT ADVANCED PLUS Bedienungsanleitung Seite 106

Problem
The lid wobbles within the
lid ring and could fall duri-
ng pouring.
The kettle is placed on the
power base and the appli-
ance is plugged in, but the
display is dark.
Almost immediately after
connecting the appliance to
the power supply, the can-
tilever moves without any
program started.
No response to your
entries.
EN
106
Reason
The lid is not installed
correctly.
The sealing ring at the rim
of the lid is damaged or
missing.
The appliance is not live.
If the appliance is idle for
more than 5 minutes, for
saving energy the appli-
ance switches OFF auto-
matically.
An initialisation of the
motor drive is performed.
The display stays dark: the
appliance is not live.
The display is illuminated:
A program is still running.
An error has occurred. An
error message is shown
on the display.
The Solution
Push the lid down in the lid ring. The lid may not protru-
de the lid ring.
The dark sealing ring at the rim of the lid holds the lid in
place within the lid ring. If required, contact your vendor.
Check, if the power plug is connected to a suitable power
outlet (see: 'Technical Specifications'). Check, if the power
outlet is live by connecting a lamp.
Press any button or remove the kettle from the power
base to re-activate the display.
This may happen when plugging in the appliance. The
motor drive is determining the topmost and/or bottom-
most position of the cantilever. Ensure that the move-
ment of the cantilever is not obstructed.
Check, if the power plug is connected to a suitable power
outlet (see: 'Technical Specifications'). Check, if the
power outlet is live by connecting a lamp.
With a program running, most buttons are blocked. Can-
cel any running program (press the illuminated start/stop
button TEA or WATER). Then try again.
See below: 'Error Messages'. If the problem persists,
contact the Gastroback Customer Care Center by phone:
+49 (0)4165/22 25-0 or e-mail info@gastroback.de.