Initial Connection Between Cockpit App And Prosthesis; Starting The Cockpit App For The First Time - Ottobock C-Leg 3C98-3 Gebrauchsanweisung

7.2 Initial connection between cockpit app and prosthesis

The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on (see Page 71).
• Bluetooth of the device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are
turned off.
The device must be connected to the internet.
•
• The serial number and Bluetooth PIN of the component being connected must be known.
They are found on the enclosed Bluetooth PIN card. The serial number begins with the letters
"SN".
INFORMATION
If the Bluetooth PIN card with the Bluetooth PIN and serial number of the component is lost,
contact your O&P professional.

7.2.1 Starting the cockpit app for the first time

1) Tap the symbol of the Cockpit app (
→ The end user license agreement (EULA) is displayed.
2) Accept the end user license agreement (EULA) by tapping the Accept button. If the end user
license agreement (EULA) is not accepted, the Cockpit app cannot be used.
→ The welcome screen appears.
3) Hold the prosthesis with the sole of the foot facing up, or connect and then disconnect the
battery charger, in order to activate recognition (visibility) of the Bluetooth connection for
2 minutes.
4) Tap the Add component button.
→ The Connection Wizard opens and guides you through the process of establishing a con­
nection.
5) Follow the subsequent instructions on the screen.
6) After the Bluetooth PIN is entered, a connection to the component is established.
→ While the connection is being established, 3 beep signals sound and the
appears.
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. This pro­
cess may take up to a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
After the initial connection to the component has been established successfully, the app will
connect automatically each time it is started. No further steps are required.
INFORMATION
After activating the "visibility" of the component (holding the component with the sole of the foot
facing up, or connecting and then disconnecting the battery charger), the component can be
recognised by another device (e.g. smartphone) within 2 minutes. If registration or establishing
the connection takes too long, the process of establishing a connection is cancelled. In this
case, hold the component with the sole of the foot facing up again, or connect and then discon­
nect the battery charger.
).
symbol
63