System Requirements; Initial Connection Between Cockpit App And Prosthesis; Starting The Cockpit App For The First Time - Ottobock Genium-Bionic Prosthetic System 3B1 Gebrauchsanweisung

INFORMATION
The language of the Cockpit app user interface can only be changed by the prosthetist using the
adjustment software.
INFORMATION
The serial number of the component to be connected has to be registered with Ottobock the
first time it is connected. If the registration is not accepted, use of the Cockpit app for this com­
ponent will be limited.
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of
the foot must point up) or by connecting/disconnecting the battery charger. Bluetooth is then
turned on for approx. 2 minutes. During this time, the app must be started and used to establish
a connection. If required, Bluetooth on the prosthesis can be switched on permanently after­
wards (see Page 87).

7.1 System Requirements

The functioning of the Cockpit app is assured on devices that support the following operating sys­
tems:
Only when "DUAL" marking is not present (see Page 60)
Android: version 4.0.3 or higher
•
Only when "DUAL" marking is present (see Page 60)
• The 4X441=* Cockpit app must be installed in version 2.0 or higher
Android: version 4.1 or higher
•
iOS (for iPhone, iPad, iPod): version 9.3 or higher. The mobile device has to support
•
Bluetooth 4.0 (BT LE).

7.2 Initial connection between cockpit app and prosthesis

The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on (see Page 87).
• Bluetooth of the device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are
turned off.
The device must be connected to the internet.
•
• The serial number and Bluetooth PIN of the component being connected must be known.
They are found on the enclosed Bluetooth PIN card. The serial number begins with the letters
"SN".
INFORMATION
If the Bluetooth PIN card with the Bluetooth PIN and serial number of the component is lost,
contact your O&P professional.

7.2.1 Starting the cockpit app for the first time

1) Tap the symbol of the Cockpit app (
→ The end user license agreement (EULA) is displayed.
2) Accept the end user license agreement (EULA) by tapping the Accept button. If the end user
license agreement (EULA) is not accepted, the Cockpit app cannot be used.
→ The welcome screen appears.
76
).