Cockpit App; System Requirements; Initial Connection Between Cockpit App And Prosthesis; Starting The Cockpit App For The First Time - Ottobock Genium 3B1-2 Gebrauchsanweisung

8 Cockpit app

The cockpit app enables switching from basic mode into the pre-configured MyModes. In
addition, information about the product (step counter, battery charge level, etc.) can be
called up.
The behaviour of the product can be changed to a certain extent on a day-to-day basis
using the app (e.g. while becoming accustomed to the product). The adjustment software
can be used to trace the change at the patient's next appointment.
INFORMATION
The Cockpit app can be downloaded free of charge from the respective online store. For more information,
please visit the website: http://www.ottobock-group.com/cockpitapp. To download the Cockpit app, the QR code
on the supplied Bluetooth PIN card can be read with the mobile device (requirement: QR code reader and cam­
era).
INFORMATION
The language of the Cockpit app user interface can only be changed using the adjustment software.

8.1 System Requirements

The functioning of the cockpit app is assured on devices with the Android operating system version 4.0.3 or higher.
The functionality was tested on the following devices:
• Samsung Galaxy S5, Galaxy S4, Galaxy S4 mini, Galaxy SIII, Galaxy SIII mini, Galaxy Note II, Galaxy
Fame
• Sony Xperia Z, Xperia Z3, Xperia J, Xperia SP
• HTC One, One mini
• LG Optimus L9, Optimus F5, Optimus F6, Optimus G, Optimus G2
• Huawei Ascend P6, Ascend G500
• Motorola Droid Razr Maxx, Moto X, Nexus 6

8.2 Initial connection between cockpit app and prosthesis

The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of the foot must
point up) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. During this time, the app must be started and used to establish a connection. If required, Bluetooth
on the prosthesis can be switched on permanently afterwards (see Page 82).
• Bluetooth of the device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are turned off.
The device must be connected to the internet.
•
• The serial number and PIN code of the component being connected must be known. They are found on the
enclosed card. The serial number begins with the letters "SN".
INFORMATION
If the Bluetooth PIN card with the PIN code and serial number of the component is lost, contact an authorised
Ottobock service centre. The serial number must be provided so a new card can be issued. This begins with the
letters SN and is found in the following position depending on the component:
Knee joints: On the inside of the frame.
Prosthetic feet: On the spherical cap.

8.2.1 Starting the cockpit app for the first time

1) Tap the symbol of the Cockpit app (
→ The end user license agreement (EULA) is displayed.
Genium 3B1-2/3B1-2=ST
).
Cockpit app
Ottobock | 71