Initial Connection Between Cockpit App And Prosthesis; Starting The Cockpit App For The First Time - Ottobock C-Leg 3C88-3 Gebrauchsanweisung

7.2 Initial connection between cockpit app and prosthesis

The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of
the foot must point up) or by connecting/disconnecting the battery charger. Bluetooth is then
turned on for approx. 2 minutes. During this time, the app must be started and used to estab­
lish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see Page 60).
• Bluetooth of the device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are
turned off.
• The device must be connected to the internet.
• The serial number and PIN code of the component being connected must be known. They are
found on the enclosed card. The serial number begins with the letters "SN".

7.2.1 Starting the cockpit app for the first time

1) Tap the symbol.
→ The end user license agreement (EULA) is displayed.
2) Accept the end user license agreement (EULA) by tapping the Accept button. If the end user
license agreement (EULA) is not accepted, the cockpit app cannot be used.
→ The welcome screen appears.
3) Tap the Add component button.
→ The "Preparation" screen appears. The serial number of the component should be
entered here.
4) Follow the subsequent instructions on the screen.
5) After the PIN code is entered, a connection to the prosthesis is established.
→ While the connection is being established, 3 beep signals sound and the
appears.
The symbol is displayed when the connection has been established.
→ Once the connection has been established successfully, the data are read from the prosthes­
is. This process may take up to a minute.
The main menu will then appear with the name of the connected prosthesis.
INFORMATION
After the initial connection to the prosthesis has been established successfully, the app will con­
nect automatically each time it is started. No further steps are required.
symbol
Ottobock | 51