AirSep VisionAire 5 Gebrauchsanweisung Für Patienten Seite 80

VisionAire™
4.0 Care and Cleaning
Disconnect the power cord from the electrical outlet before you
clean the unit to prevent accidental electrical shock hazards.
Only your Equipment Provider or a qualified service technician
should remove the covers or service the unit.
Do not use liquid directly on the unit. A list of undesirable
chemical agents includes but is not limited to the following:
alcohol and alcohol-based products, concentrated chlorine-
based products (ethylene chloride), and oil-based products
(Pine-Sol®, Lestoil®). These are NOT to be used to clean the
plastic housing on the unit, as they can damage the unit's
plastic.
Clean the cabinet, control panel, and power cord only with a
mild household cleaner applied with a damp cloth or sponge,
and then wipe all surfaces dry. Do not allow any liquid to get
inside the device.
Replace the disposable cannula periodically following normal
usage according to your Equipment Providers
recommendations.
To prevent a voided AirSep warranty, follow all manufacturers'
instructions.
AirSep does not recommend the sterilization of this equipment.
®
AirSep Corporation
MN137-1 rev. D
EN EN
4.1 Humidifier Bottle (optional)
4.2 Outside Cabinet
Use a mild household cleaner applied with a damp cloth or sponge to
clean the exterior of the concentrator, and then wipe all surfaces dry.
Do not allow any liquid to get inside the device.
EN-19 EN-20
•
Check water level daily and add water as needed
•
To clean and disinfect the humidifier, follow your Equipment
Provider's instructions, or the instructions included with the
humidifier bottle.
VisionAire™
®
AirSep Corporation
MN137-1 rev. D